Changes between Version 3 and Version 4 of ControlSystems/Electrical/Training/FallTraining


Ignore:
Timestamp:
Dec 6, 2020, 1:35:21 PM (5 years ago)
Author:
Ryan Nguyen
Comment:

--

Legend:

Unmodified
Added
Removed
Modified

  • ControlSystems/Electrical/Training/FallTraining

    v3 v4  
    11== Project 1: Making an LED light up
    2 Materials/parts needed\\
    3 
     2Materials/parts needed//
    43For this project, you can use either your Arduino kit or TinkerCAD. Note that if you don’t use a high enough resistance for your real life circuit, the LED might stop working permanently.
    54Parts needed: Arduino Uno, wires, LED, breadboard, and a 370-500 ohm resistor.
    6 Steps
     5
     6Steps//
    77Once you have all the parts laid out, connect the components together like shown in the picture above, but before you do that, you will need the correct resistance for your resistor.
    88How do you find the correct resistor? You can use this chart to figure out the resistances of the resistors in your kit: