Context Navigation

ProjectOne

v1	v2
39	39	}\\
40	40
41		f. Just copy and paste this into the code section of TinkerCAD (its the button next to start simulation, and after that, change the code type to text, and not blocks), or your arduino software (which is found at ~~Software \| Arduino~~) which you will need to have the arduino connected to your computer by USB to upload the code.
	41	f. Just copy and paste this into the code section of TinkerCAD (its the button next to start simulation, and after that, change the code type to text, and not blocks), or your arduino software (which is found at https://www.arduino.cc/en/software) which you will need to have the arduino connected to your computer by USB to upload the code.
42	42
43	43	g. Finally, press start simulation on TinkerCAD, or press the upload button on your arduino software if you are using the arduino kit.